石油炼制与化工

• 加工工艺 • 上一篇    下一篇

脱沥青油及其糠醛抽余油的催化裂化性能研究

杜平安1,任满年2,应卫勇3   

  1. 1. 华东理工大学;中国石化洛阳分公司
    2. 中国石化洛阳分公司
    3. 华东理工大学化工工艺所
  • 收稿日期:2011-04-18 修回日期:2011-06-14 出版日期:2011-12-12 发布日期:2011-12-12
  • 通讯作者: 应卫勇

CATALYTIC CRACKING PERFORMANCES OF DAO AND ITS RAFFINATE OILS FROM FURFURAL EXTRACTION

  • Received:2011-04-18 Revised:2011-06-14 Online:2011-12-12 Published:2011-12-12

摘要: 采用提升管催化裂化装置,考察脱沥青油(DAO)以及抽提条件分别为剂油质量比2:1、抽提温度80℃;剂油质量比2:1、抽提温度85℃两种工况下对DAO进行糠醛抽提所得到的抽余油A与B等三种催化裂化原料的裂化性能。实验结果表明:DAO经过糠醛抽提后所得抽余油的催化裂化转化率较高,轻质油收率较高,重油和焦炭产率较低,其催化裂化性能和裂化产品的性质均优于DAO。

关键词: 脱沥青油, 糠醛, 溶剂抽提, 催化裂化, 抽余油

Abstract: In this paper, pilot plant riser reactor was used to evaluate the catalytic cracking performances of desaphalted oil (DAO) and its raffinate oils (denoted as feed A and feed B), which were obtained by extracting DAO with furfural under the conditions of furfural/DAO mass ratio of 2, extraction temperature of 80 ℃ and 85 ℃, respectively. Experimental results indicated that compared with DAO, both feed A and feed B exhibited improved catalytic cracking performances: higher heavy oil conversion and light oil yield, lower yields of coke and slurry oil, besides, the properties of cracking products from feed A and feed B are also better in some ways.

Key words: deasphalted oil, furfural, solvent deasphalting process, catalytic cracking, raffinate oil