旋流雾化喷嘴内气液两相流动的特性研究

石油炼制与化工 ›› 2020, Vol. 51 ›› Issue (3): 54-61.

旋流雾化喷嘴内气液两相流动的特性研究

王娟^1,2,高助威^1,3,张雪淼^1,2,王江云^1,2,毛羽¹

1. 中国石油大学（北京）重质油加工国家重点实验室
2. 过程流体过滤与分离技术北京市重点实验室
3. 海南大学化学工程与技术学院

收稿日期:2019-07-08 修回日期:2019-09-09 出版日期:2020-03-12 发布日期:2020-03-31
通讯作者: 高助威 E-mail:gzwwer@126.com
基金资助:
国家自然科学基金（21106181）项目;中国石油大学（北京）科研创新项目（2462015YQ0303）

STUDY ON CHARACTERISTICS OF GAS-LIQUID TWO-PHASE FLOW IN SWIRL ATOMIZING NOZZLE

Received:2019-07-08 Revised:2019-09-09 Online:2020-03-12 Published:2020-03-31
Supported by:

摘要/Abstract

摘要： 采用试验和数值模拟相结合的方法，对旋流雾化喷嘴内部气液两相流动特性进行研究，揭示旋流雾化喷嘴内部的流动机理，有效预测其雾化特性。计算模型采用雷诺应力(RSM)湍流模型和欧拉-欧拉(Euler-Euler)两相流模型。结果表明，当气液体积比为600、气体流量小于25 m3/h时，模拟计算结果与试验数据吻合较好。在喷口内部，由于流通截面的减小，二甘醇的切向速度迅速增大，在喉部区域达到峰值，流经喉部后，由于流通面积的增加，切向速度呈减小趋势。随着气体流量的增加，二甘醇的射程越来越远，当气体流量分别为15，20，30 m3/h时，二甘醇的分配不均匀度分别为27.94%，26.05%，33.42%，呈现先减小后增大的趋势。

关键词: 气液两相流, 旋流雾化, 数值模拟, 不均匀度

Abstract: By means of experiment and numerical simulation and diethylene glycol as test material, the gas-liquid two-phase flow characteristics in a swirl atomizer nozzle were studied, the flow mechanism in swirl atomizer nozzle was revealed, and the atomizing characteristics in the swirl atomizer nozzle were predicted effectively. The RSM turbulence model and the Euler-Euler multiphase flow model were used in the numerical simulations. The results showed that when the gas/liquid ratio was 600 and the gas flow rate was less than 25 m3/h, the simulation results were in good agreement with the experimental data. Due to the decrease of flowing area, the tangential velocity of diethylene glycol inside the swirl nozzle increased rapidly, and reached a peak value in the throat area. After that, the tangential velocity decreased gradually due to the increase of the flow area. With the increase of gas flux, the speed range of diethylene glycol was farther and farther. When the gas flow rate were 15, 20 and 30 m3/h, the distributing uniformity of diethylene glycol were 27.94%, 26.05% and 33.42%, respectively, showing a trend of decrease first and then increase.

Key words: gas-liquid flow, swirling flow, numerical simulation, unevenness

中图分类号:

王娟高助威张雪淼王江云毛羽. 旋流雾化喷嘴内气液两相流动的特性研究[J]. 石油炼制与化工, 2020, 51(3): 54-61.

参考文献

[1] 李立权, 陈崇刚. 大型加氢反应器内构件的研究及工业应用[J]. 炼油技术与工程, 2012, 42(10):27-32.
[2] 陈斌, 郭烈锦, 张西民, 等. 喷嘴雾化特性实验研究[J]. 工程热物理学报, 2001, 02:237-240.
[3] 冉景煜, 张力, 辛明道, 等. 渐扩切向槽式低压旋流喷嘴流场的数值模拟[J]. 工程热物理学报, 2002, 23(4):586-588.
[4] 岳明, 徐行, 杨茂林. 离心式喷嘴内气液两相流动的数值模拟[J]. 工程热物理学报, 2003, 24(5):888-890.
[5] 程卫民, 周刚, 左前明, 等. 喷嘴喷雾压力与雾化粒度关系的实验研究[J]. 煤炭学报, 2010 (8):1308-1313.
[6] 曾卓雄, 姜培正, 谢蔚明. 喷嘴雾化粒径的实验研究[J]. 西安交通大学学报, 2000 (4):75-77.
[7] Yao S S, Zhang J, Fang T G. Effect of viscosities on structure and instability of sprays from a swirl atomizer[J]. Experimental Thermal and Fluid Science, 2012, 39(5):158-166.
[8] 张永良. 离心喷嘴雾化特性实验研究和数值模拟[D]. 北京: 中国科学院研究生院(工程热物理研究所), 2013.
[9] Lan Z K, Zhu D H, Tian W X, et al. Experimental study on spray characteristics of pressure-swirl nozzles in pressurizer[J]. Annals of Nuclear Energy, 2014, 63(1):215-227.
[10] 魏超. 一种超细雾化喷嘴的数值模拟及结构优化研究[D]. 北京: 华北电力大学, 2015.
[11] Zhang L H, Shao J X, Chen X M. CFD simulation of nozzle characteristics in a gas aggregation cluster source[J]. Vacuum, 2016, 129:105-110.
[12] Qin C, Loth E. Numerical description of a pressure-swirl nozzle spray[J]. Chemical Engineering and Processing: Process Intensification, 2016, 107:68-79.
[13] Chobad A. Liquid flow in a simplex swirl nozzle[J]. International Journal of Multiphase Flow, 2016, 79:225-235.
[14] 聂涛. 旋流式喷嘴雾化特性研究[D]. 太原: 太原理工大学, 2016.
[15] Liu X F, Xue R, Ruan Y X, et al. Flow characteristics of liquid nitrogen through solid-cone pressure swirl nozzles[J]. Applied Thermal Engineering, 2017, 110:290-297.
[16] Sies M F, Madzlan N F, Asmuin N, et al. Determine spray droplets on water sensitive paper (WSP) for low pressure deflector nozzle using image J[J]. IOP Conference series: Materials Science and Engineering, 2017, 243(1):012047.
[17] 王国辉, 蔡体敏, 何国强, 等. 一种旋流式喷嘴的实验和数值研究[J]. 推进技术, 2003, 24(1):28-33.
[18] 江帆, 黄鹏. Fluent高级应用与实例分析[M]. 北京: 清华大学出版社, 2008:13-19.
[19] 方爱平, 田蓬勃, 孙迪昊, 等. 排水口旋涡的压强与速度分布[J]. 物理与工程, 2016, (02):80-84.
[20] 苏东涛, 郭雪岩. 基于DES方法平底水力旋流器内部流场特征的数值分析[J]. 力学季刊, 2014, (01):22-31.
[21] 王乐勤, 尹俊连, 孙青军, 等. 涡流二极管泵内部流场的数值模拟[J]. 流体机械, 2009, (04):25-28.
[22] 赵永志, 顾兆林, 郁永章, 等. 自由水涡结构及运动特征的数值研究[J]. 西安交通大学学报, 2003, (01):85-88.
[23] 老大中, 黄钟岳, 沈自求. 涡流管喷嘴附近截面气流参数的近似计算[J]. 航空发动机, 1997, (01):26-29.
[24] 姚增权, 马进. 简式旋流喷嘴的设计[J]. 电力环境保护, 2002, 18(3):1-7.