石油炼制与化工 ›› 2012, Vol. 43 ›› Issue (8): 33-37.

• 基础研究 • 上一篇    下一篇

Ag/γ-Al2O3催化剂催化氧化深度脱硫及反应动力学模型探索

宋华1,白冰1,宋华林2,冯化林1   

  1. 1. 东北石油大学化学化工学院
      2.  牡丹江医学院医学影像学院
  • 收稿日期:2011-11-15 修回日期:2011-12-09 出版日期:2012-08-12 发布日期:2012-07-30
  • 通讯作者: 宋华 E-mail:songhua2004@sina.com
  • 基金资助:

    黑龙江省教育厅科学技术研究项目

DEEP OXIDATION DESULFURIZATION CATALYZED BY Ag/γ-Al2O3 CATALYST AND KINETICS MODEL EXPLORATION

  • Received:2011-11-15 Revised:2011-12-09 Online:2012-08-12 Published:2012-07-30

摘要: 以噻吩/石油醚模拟油为原料、Ag/γ-Al2O3为催化剂、氧气为氧化剂,研究了催化氧化深度脱硫技术,对催化剂进行了X射线衍射(XRD)和低温氮吸附表征,并考察了催化剂用量、反应温度、反应时间和萃取条件对脱硫效果的影响。在噻吩/石油醚模拟油20 mL、Ag/γ-Al2O3催化剂0.12 g、氧化温度70 ℃的反应条件下,氧化50 min后,将得到的产物采用甲醇为萃取剂,在20 ℃、剂油体积比1︰1的条件下萃取30 min,脱硫率达到98.1%。反应动力学研究结果表明,噻吩氧化过程可用一级反应动力学方程式来表示,其表达式为:k=0.049 45exp[-10 683.4/(RT)]。

Abstract: The deep catalytic oxidation desulfurization of model oil (thiophene/petroleum ether) was studied using Ag/γ-Al2O3 as catalyst and gaseous oxygen as oxidant. The catalyst was characterized by X-ray diffraction (XRD) and low temperature N2-adsorption techniques. The effects of catalyst amount, reaction temperature and time, as well as extraction conditions on the oxidation desulfurization were investigated. Test results showed that using 20 mL of model oil, 0.12 g of catalyst, reacting at 70 ℃ for 50 min, the obtained material was extracted by methanol at 20 ℃ for 30 min with a solvent/oil volume ratio of 1, the rate of desulphurization reached 98.1 %. The kinetic study indicates that catalytic oxidation of thiophene is a pseudo first-order reaction, which could be expressed as k =0.049 45exp[-10 683.4/(RT)].