石油炼制与化工 ›› 2013, Vol. 44 ›› Issue (1): 60-64.
• 加工工艺 • 上一篇 下一篇
颜世山,柴建锋,吴言泽,杜亮
收稿日期:
修回日期:
出版日期:
发布日期:
通讯作者:
Received:
Revised:
Online:
Published:
摘要： 分析了中国石化济南分公司900 kt/a S Zorb装置自开工以来加工量低于设计值的主要原因。通过采取增加原料进装置过滤器、对原料换热器进行抽芯清洗、提高催化裂化装置提升管出口温度、提高催化裂化汽油直供温度、调整吸附剂循环再生频次、加热炉燃料改用重瓦斯、降低反应温度和采用高纯度氢气等措施，在生产的汽油产品满足国III排放标准要求的前提下，S Zorb装置的加工量提高了11 t/h左右。
关键词: S Zorb装置, 加工量, 加热炉, 反应温度 , 吸附剂
Abstract: The main causes of lower processing capacity than the design value of the 900 kt/a S Zorb unit in SINOPEC Jinan Company were analyzed and counter measures were discussed. Since adopting measures, such as adding another feed filter, cleaning heat exchanger of feed, increase the riser outlet temperature of FCC unit, increase the direct feed supply temperature from FCC unit to S Zorb unit, adjusting the cycle rate of sorbent and frequency of regeneration, using heavy gas as fuel of heating furnace, reducing the reaction temperature and using high-purity hydrogen, the processing capacity of said S Zorb unit has an increment of about 11 t/h and the gasoline product also well meets the requirement of National Emission Standard III.
Key words: S Zorb unit, processing capacity, furnace, reaction temperature , adsorbent
颜世山 柴建锋 吴言泽 杜亮. 提高S Zorb装置加工量的措施[J]. 石油炼制与化工, 2013, 44(1): 60-64.
0 / / 推荐
导出引用管理器 EndNote|Ris|BibTeX
链接本文: http://www.sylzyhg.com/CN/
http://www.sylzyhg.com/CN/Y2013/V44/I1/60
京公网安备 11010802027553号
