Ni-Mo-W非负载型催化剂加氢脱硫性能的改进及结构探究

石油炼制与化工 ›› 2017, Vol. 48 ›› Issue (8): 73-78.

Ni-Mo-W非负载型催化剂加氢脱硫性能的改进及结构探究

赵婉竹¹,王晨^1,2,施岩¹,孙娜¹,王海彦¹,赵玉柱³

1. 辽宁石油化工大学化学化工与环境学部
2. 中国石化抚顺石油化工研究院
3. 中国石油抚顺石化分公司

收稿日期:2017-02-06 修回日期:2017-03-24 出版日期:2017-08-12 发布日期:2017-07-19
通讯作者: 施岩 E-mail:shiyan1816@163.com
基金资助:
辽宁省教育厅资助项目

STUDY OF UNSUPPORTED Ni-Mo-W CATALYST STRUCTURE AND HDS PERFORMANCE IMPROVEMENT

Received:2017-02-06 Revised:2017-03-24 Online:2017-08-12 Published:2017-07-19
Supported by:

摘要/Abstract

摘要： 在共沉淀法制备三元（Ni-Mo-W）非负载型催化剂过程中加入聚乙二醇（PEG），采用XRD、BET及微反活性评价考察PEG的最佳相对分子质量及加入量，采用Py-IR，SEM，TEM等后续表征分析最佳条件下PEG对催化剂性质和脱硫活性的影响，采用XRD、LRS对Ni-Mo-W复合氧化物的结构进行深入探究。结果表明：在PEG的相对分子质量为600、加入量为Mo物质的量的20%时，催化剂对劣质柴油的脱硫率最高，可达99.8%；此条件下的Ni-Mo-W非负载型催化剂形态规整，活性组分分布均匀，相互间排列有序，孔隙最为发达，酸位得到充分暴露。合成的Ni-Mo-W复合氧化物是具有不同Mo、W配位的新型Ni基化合物，Ni-W构成主体及表层，内部填充部分主要由Ni-Mo构成。

关键词: 三元非负载型催化剂, 聚乙二醇, 劣质柴油, 加氢脱硫

Abstract: The advantages of unsupported catalyst in the HDS are obvious and widely paid much attention. In this paper, PEG was added in the process of preparing trimetalic unsupported catalyst by co-precipitation, and the resulting unsupported catalyst was then characterized by XRD, BET, and evaluated in a micro-reactor system to test the optimal amount and the molecular weight of PEG added. Py-IR, SEM, TEM techniques were used to investigate the effect of PEG under optimal conditions on the properties and the HDS activity of the catalyst. The structures of the unsupported Ni-Mo-W catalysts in oxidation state were analyzed by XRD and LRS. The results show that the trimetalic unsupported catalyst prepared by adding PEG with molecular weight of 600 as Mo moles of 20% has the best HDS activity, the HDS rate reaches to 99.8%. Under the best catalyst preparation conditions, the Ni-Mo-W composite has a regular morphology, better distribution of active component, ordered arrangement, optimal pore structure, and fully exposed acid sites. The Ni-Mo-W composite in oxidative state is a new type of Ni-based compound with different Mo and W coordination modes, the bulk and the surface layer of the catalyst are composed of Ni-W, while part of the internal contains Ni-Mo structure.

Key words: trimetalic unsupported catalyst, polyethyleneglycol, inferior diesel, hydrodesulfurization

中图分类号:

赵婉竹王晨施岩孙娜王海彦赵玉柱. Ni-Mo-W非负载型催化剂加氢脱硫性能的改进及结构探究[J]. 石油炼制与化工, 2017, 48(8): 73-78.

参考文献

[1]Kallinikos L E, Jess A, Papayannakos N G.Kinetic study and H2S effect on refractory DBTs desulfurization in a heavy gasoil[J].Journal of Catalysis, 2010, 269(1):169-178 [2]Abghari S Z, Shokri S, Baloochi B, et al.Analysis of sulfur removal in gasoil hydrodesulfurization process by application of response surface methodology[J].Korean Journal of Chemical Engineering, 2011, 28(1):93-98 [3]张爱华.我国石油消费市场回顾及发展趋势预测[J].石油化工技术经济, 2007, 23(3):30-32 [4]Infantes Molina A, Cecilia J A, Pawelec B, et al.Ni2P and CoP catalysts prepared from phosphite-type precursors for HDS–HDN competitive reactions[J].Applied Catalysis A: General, 2010, 390(1):253-263 [5]Lihua L, Shuqun L.Ni2P-MoS2γ-Al2O3 Catalyst for Deep Hydrodesulfurization via the Hydrogenation Reaction Pathway[J].China Petroleum Processing & Petrochemical Technology, 2014, 16(4):12-18 [6]陈燕蝶, 王璐, 刘铁峰, 等.柴油超深度加氢脱硫催化剂研究进展[J]. 化学反应工程与工艺, 2013 (5): 392-400. [7]Guo R, Shen B, Fang X, et al.Catalysis Performance of Co-Mo and Ni-Mo-W in Deep Hydrodesulfurization of Diesel Oils[J]. Journal of East China University of Science and Technology (Natural Science Edition), 2012, 5: 006. [8]葛晖, 李学宽, 秦张峰, 等.油品深度加氢脱硫催化研究进展[J]. 化工进展, 2008 (10). [9]白振江, 王亚萍, 殷长龙, 等.镍前躯体对非负载型--柴油加氢催化剂结构和性能的影响[J].石油炼制与化工, 2015, 46(4):40-45 [10]Olivas A, Galván D H, Alonso G, et al.Trimetallic NiMoW unsupported catalysts for HDS[J].Applied Catalysis A: General, 2009, 352(1):10-16 [11]赵蕾艳, 殷长龙, 刘欢, 等.非负载型催化剂上柴油深度加氢脱硫工艺条件研究[J].石油炼制与化工, 2013, 44(10):38-43 [12]Eijsbouts S, Plantenga F, Leliveld B, et al.STARS and NEBULA–new generations of hydroprocessing catalysts for the production of ultra low sulfur diesel[J].Prepr. Pap.-Am. Chem. Soc., Div. Fuel Chem, 2003, 48(2):495- [13]王震, 徐学军, 史开洪, 等.体相法催化剂首次工业应用[J].当代石油石化, 2008, 16(8):35-38 [14]Eijsbouts S, Mayo S W, Fujita K.Unsupported transition metal sulfide catalysts: From fundamentals to industrial application[J]. Applied Catalysis A: General, 2007, 322: 58-66. [15]陈庆春, 邓慧宇, 马燕明.聚乙二醇在新材料制备中的作用及其机理[J].日用化学工业, 2002, 32(5):35-37 [16]Yin C L, Bai Z J, Zhao L Y, Zhang J P, et al.Effect of PEG on the Structure and Hydrodesulfurization Performance of Unsupported Ni-Mo Catalyst[J]. Hans Journal of Chemical Engineering and Technology, 2013, 3: 208. [17]钦柏豪, 杨运泉, 刘文英, 等.表面活性剂对水热法合成加氢脱硫催化剂的影响[J].燃料化学学报, 2015, 40(11):1384-1389 [18]朱崇业, 张春芬, 姚文华, 等.Ni-Mo-W/γ-Al_2O_3 催化剂的程序升温还原和拉曼光谱的研究[J]. 分子光谱学进展 (Ⅸ), 1996. [19]Cervantes-Gaxiola M E, Arroyo-Albiter M, Pérez-Larios A, et al.Experimental and theoretical study of NiMoW, NiMo, and NiW sulfide catalysts supported on an Al Ti Mg mixed oxide during the hydrodesulfurization of dibenzothiophene[J]. Fuel, 2013, 113: 733-743. [20]伊艳娇.非负载 Ni-Mo-S/Ni-Mo-WS 催化剂及其二苯并噻吩加氢脱硫性能[D]. 大连理工大学, 2014.