›› 2018, Vol. 49 ›› Issue (12): 58-63.

• 加工工艺 • 上一篇    下一篇

煤焦油制蜡技术的研究

周秋成   

  1. 榆林煤化工产业促进中心
  • 收稿日期:2018-04-26 修回日期:2018-07-06 出版日期:2018-12-12 发布日期:2019-01-03
  • 通讯作者: 周秋成 E-mail:491680613@qq.com
  • 基金资助:
    陕西省重点研发计划项目

TECHNOLOGY FOR WAXMAKING FROM COAL TAR

  • Received:2018-04-26 Revised:2018-07-06 Online:2018-12-12 Published:2019-01-03

摘要: 以中低温煤焦油轻油为原料,采用直接加氢-溶剂脱蜡耦合工艺制备煤基蜡;在三管式固定床加氢反应器,考察反应温度、反应压力及空速对煤焦油直接加氢产物性质及正构烷烃含量的影响;采用溶剂脱蜡技术得到煤基蜡产品,并对其熔点、正构烷烃组分含量进行测定。结果表明:煤焦油直接加氢-溶剂脱蜡耦合工艺的最优条件为反应温度380 ℃,反应压力13 MPa,液体体积空速0.3 h-1,酮苯质量比8:1,剂油质量比5:1;在最优条件下制备的煤基蜡熔点为50.7 ℃,正构烷烃质量分数为93.7%。

关键词: 煤焦油, 加氢, 石蜡, 正构烷烃

Abstract: The light oil from middle and low temperature coal tar was used to make wax by hydrofining and then solvent dewaxing process. The effect of reaction temperature,pressure,LHSV on the properties and content of paraffin of the waxes were investigated using three hydrofining reactors in series. The melting point and content of n-alkanes of the waxes obtained by solvent dewaxing process were determined. The optimal reaction conditions of the process are as follows:reaction temperature of 380 ℃,reaction pressure 13 MPa,LHSV 0.3 h-1, the ratio of ketone-benzene and solvent-oil is 8:1 and 5:1,respectively. The final wax product has a melting point of 50.7℃,n-alkane content of 93.7%.

Key words: coal tar, hydrofining, wax, n-alkane