›› 2019, Vol. 50 ›› Issue (6): 24-27.
• 加工工艺 • 上一篇 下一篇
申志峰
收稿日期:
修回日期:
出版日期:
发布日期:
通讯作者:
Received:
Revised:
Online:
Published:
摘要: 催化裂化装置在低负荷下运行时,分馏塔顶部负荷过小,导致油气分压低而水蒸气分压变高;同时,由于局部传热不均匀,水蒸气容易液化,造成分馏塔顶部塔盘和顶循环系统结盐。为了增加分馏塔顶部负荷,投用粗汽油走急冷油线进提升管回炼。投用后的分析结果表明,此措施在抑制分馏塔结盐的同时,产品分布也得到一定改善。
关键词: 催化裂化, 低负荷, 结盐, 粗汽油, 急冷油, 产品分布
Abstract: The top load of the main fractionating column is too small under low load conditions in fluid catalytic cracking unit, resulting in lower oil and gas partial pressure and higher water vapor pressure; and the water vapor is easy to liquefy due to uneven heat transfer, resulting in salt deposition on the top tray and top circulation system of the column. In order to increase the top load of the main fractionating column, crude gasoline was introduced into the riser via the quench oil line. The operation results showed that this measure not only inhibited salt deposition in the column, but also improved product distribution.
Key words: fluid catalytic cracking, low load, salt deposition, crude gasoline, quenching oil, product distribution
申志峰. 催化裂化装置低负荷下粗汽油作急冷油效果分析[J]. , 2019, 50(6): 24-27.
0 / / 推荐
导出引用管理器 EndNote|Ris|BibTeX
链接本文: http://www.sylzyhg.com/CN/
http://www.sylzyhg.com/CN/Y2019/V50/I6/24